User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Using the GoBox
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 37 of 63
The profiles which can be selected this way are the same as on the GoBox front panel. I.e. only profiles which have a
duplexer group tag of All or match the installed duplexer have a Select action.
4.3 Stopping Repeater Operation
The GoBox can be returned to a standby state whereby it does not repeat according to any operational profile, but can be
programmed using the web interface.
4.3.1 Front Panel
Press the rotary dial, turn it while holding the dial down until “Standby” appears in the display, and release the dial.