User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Configuration
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 33 of 63
3.4.2 Setting the start-up profile for a Duplexer
To define different start-up profiles for different duplexers use the following steps:
Click on the Duplexer Group Tags menu item on the navigation pane and press the + Add Duplexer Group Tag button on
the content pane to show the Add Duplexer Group Tag form.
The following fields will be required to be completed.
Field
Description
Duplexer Group Tag
A unique name for this duplexer group. Allowed characters are A-Z, a-z, 0-9 and '-'. Up to 8 characters can
be entered. The name “All” cannot be used.
Comment (Optional)
An optional comment describing this duplexer group tag.
Rx Freq
The receive frequency of the duplexer group
Tx Freq
The transmit frequency of the duplexer group
Start-up Profile
The operational profile to be selected when the GoBox powers on
At least one operational profile is required.
!
The last active profile (before the GoBox was shut down) takes precedence over the Start-up Profile. However, if
this profile is not compatible with the currently installed duplexer, the Start-up profile will be used..
!