User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Configuration
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 32 of 63
3.4 Managing Duplexers
3.4.1 Writing a Duplexer Group Tag
Before the GoBox will recognise a duplexer and allow operational profiles to be associated with it, you must write a
duplexer group tag to the duplexer’s internal memory. To do this use the following steps:
Click on the Duplexer menu item on the navigation pane and press the Edit button on the content pane to show the Edit
Duplexer form.
The following fields will be required to be completed.
Field
Description
Tag
A unique name for this duplexer group. Allowed characters are A-Z, a-z, 0-9 and '-'. Up to 8 characters can
be entered. The tag “All” is reserved and cannot be used.
Once the form has been completed, press the Save button to write to the duplexer or Cancel to abort the operation.
Writing to the duplexer will take several seconds. If the page does not update automatically after a short time, it
may be necessary to click the Refresh button to verify the tag has been written.
!