User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Configuration
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 25 of 63
3.3.1.2 Networked Mode
To create a new P25 Conventional Networked Repeat Profile, click the P25 Networked menu item in the navigation pane
and click on + Add Profile button on the content pane.
The following fields will be required to be completed.
Profile Name
Duplexer Group Tag
Rx P25 Type
Rx Frequency
Rx NAC (if Rx P25 Type is Normal or Selective)
Rx/Tx Talkgroup (if Rx P25 Type is Selective)
Tx Frequency
Tx NAC
Tx Power
Tx Hang Time
Network (reference to a Network configuration, see section 4.5.6)
Network Type
For RNC Network Type the following fields are required:
Site ID
Site Subscriber ID
Network Group Address (WACN ID, System ID, Group ID)
For DFSI Network Type the following fields are required:
DFSI Control Port
DFSI Voice Port
DFSI Data Port
The fields are described in detail below in section 3.3.4.
Once the form has been completed, press the Save button to save the profile or Cancel to abort the operation.
Once Save is pressed and all fields contain valid values, the profile is written to the GoBox.
!
Once Save is pressed and all fields contain valid values, the profile is written to the GoBox.
!