User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Configuration
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 24 of 63
3.3 Managing Operational Profiles
GoBox profiles are managed under the Profiles heading in the navigation pane. The types of profiles which can be
configured depend on the installed options.
3.3.1 Adding a P25 Conventional Repeating Profile
3.3.1.1 Standalone Mode
To create a new P25 Conventional Standalone Repeat Profile, click the P25 Conventional menu item in the navigation pane
and click on + Add Profile button on the content pane.
The following fields will be required to be completed.
Profile Name
Duplexer Group Tag
Rx P25 Type
Rx Frequency
Rx NAC (if the Rx P25 Type is Normal or Selective)
Rx/Tx Talkgroup (if the Rx P25 Type is Selective)
Tx Frequency
Tx NAC (if the Rx P25 Type is Normal or Selective)
Tx Power
Tx Hang Time
The fields are described in detail below in section 3.3.4.
Once the form has been completed, press the Save button to save the profile or Cancel to abort the operation.
If the user enters an invalid value in any form field, the GoBox will reject the profile, and the reason will be
displayed on the form in red.
!
Hovering over any form field name that has a dotted underline will display a popup tip to assist completing the
form.
!