User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Getting Started
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 14 of 63
2.2.3.4 RF Connectors
The standard RF Connector option is for one Tx/Rx RF Connector.
There is an option for a 2
nd
RF Connector which can function as a Rx only RF Connector.
The function of each RF Connectors will change depending upon the type of duplexer module fitted. The Standard Tx/Rx
RF Connector will always contain the Transmit function. The functions of the RF connectors depend upon the type of
Duplexer Module fitted as summarized in the following table.
Duplexer Module Type
Standard Tx/Rx
RF Connector Function
2
nd
Rx Only RF
Connector Function
Duplexer (Standard) Module
Transmit and Receive
No RF Function
Duplexer Bypass Module
Transmit Only
Receive Only
Both the standard Tx/Rx RF Connector and the optional 2
nd
Rx Only connector are N-Type connectors.
For details of approved transmit antenna types, refer to Table 2 and Table 3 in the Important Safety Information found in
the beginning of this document.
! !! !
Do not attach an Ethernet cable to both Ethernet ports on the GoBox at the same time to a switch/router as it may
cause some network switches/routers to fail.
!
To achieve optimum performance, antennas should be setup according to antenna manufacture specifications,
including tuning of antennas, and appropriate mounting over ground planes.
!
Refer to the safety guidelines in the section Human Exposure to Radio Waves.
!