User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Getting Started
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 12 of 63
2.2 Overview
2.2.1 Locking Clamps
The GoBox has two locking clamps on either side of the carry handle to lock the lid firmly against the chassis.
To disengage the locking clamps, place your finger behind the clamps and pull away and up towards the lid. Lift the curved
section of the locking clamp up and out of the channel in the top of the lid and repeat for the other clamp to release the
GoBox lid.
2.2.2 Lid
The GoBox lid has been designed to provide a seal to prevent dust and water from entering the GoBox when the locking
clamps are fully engaged.
Both locking clamps must be fully engaged to ensure a correct seal.
!
Once the GoBox has been programmed, the lid only needs to be opened to turn the GoBox on when powered
under batteries. The lid does not need to be closed during operation however it is recommended to be closed
during field use.
!
The lid gasket located around the lid perimeter of the chassis must be kept clean and free of any debris. It should
be inspected before field operation and cleaned or replaced if damaged, otherwise water or dust could penetrate
and damage GoBox electronics.
!