User's Manual
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Configuration
- 3.1 Before you begin
- 3.2 Connecting to your GoBox configuration interface
- 3.3 Managing Operational Profiles
- 3.4 Managing Duplexers
- 4 Using the GoBox
- 4.1 Turning your GoBox On
- 4.2 Selecting an Operational Profile
- 4.3 Stopping Repeater Operation
- 4.4 Checking GoBox Status
- 4.5 Administration
- 5 Troubleshooting
- 5.1 Cannot connect to the GoBox web interface
- 5.2 Network Status icon displays REG ERR
- 5.3 Network Status icons displays PSWD
- 5.4 Network Status icon WWW does not turn solid
- 5.5 Network Status icon VPN does not turn solid
- 5.6 Network Status icon RNC does not turn solid
- 5.7 Status window displays Err:Ctrl
- 5.8 Status window displays Err:Rad1, Err:Rad2 or Err:Rad12
- 5.9 There are no profiles to select on the GoBox control panel
- 5.10 GoBox web interface displays “Template Syntax Error”
- 5.11 The LEDs and the LCD backlight do not turn on
- 5.12 When turning on the GoBox, the LEDs flash rapidly for a second, and the LCD stays blank
- 6 Glossary
SFFR-6 User Manual
Introduction
Doc ID: ES1002-UM02-v508
Copyright © 2021 Etherstack
Page 8 of 63
User Interface
Power Button
Standard
Function Buttons
Standard
Rotary Dial / Button
Standard
Status Indicators
Power On
Standard
Receive Signal Detected
Standard
Transmit Enabled
Standard
AC Power Detected
Standard
DC Power Detected
Standard
Battery 1 Detected
Standard
Battery 1 Power Level
Standard
Battery 1 Charging Status
Standard
Battery 2 Detected
Standard
Battery 2 Power Level
Standard
Battery 2 Charging Status
Standard
Active Profile
Standard
Network Connection Status
Standard
Network Controller Status
Standard
LCD Backlight
Standard
Software Features
Profile Management
Standard
Profile Ordering
Standard
Accidental Profile Change Protection
Standard
Remote Profile Change
Standard
Auto Profile Filtering via Duplexer Group Tag on GoBox Interface
Standard
Auto Profile Selection for Duplexer Group Tag
Standard
Duplexer Viewer
Standard
Auto LCD Backlight Enable
Standard
Configurable LCD Backlight Level
Standard
Tamper Protection and PIN Access
Option
AES 256 Software Encryption
Option
AES 256 Hardware Encryption (FIPS 140-2)
Option
Administration
Web Based Configuration Tool
Standard
Access Control
Standard
Configuration Backup
Standard
Configuration Restore
Standard
Firmware Update
Standard