Operating Instructions and Installation Instructions
7
ASSEMBLY AND OPERATING INSTRUCTIONS | e NEXHO-CR – POWER-CONTROL MODULE
WHEN TROUBLESHOOTING
PLEASE CONTACT THE CUSTOMER CARE OF YOUR SPECIALIST DEALER.
WARNING: Electrical and electronic appliances often contain prescious materials. But they can also contain harmful substances that were
necessary for their function and safety. They can harm the environment if disposed or mishandled. Please help to protect our environment!
Therefore do not dispose of this device in the residual waste. Dispose of this unit in accordance with local regulations. Dispose of the packaging
materials, replacement parts or equipment parts properly.
INDICATION: Subject to technical modications. Changes, errors and misprints shall not be entitled to compensation.
HOW DO I RESET A e NEXHO-CR POWER-CONTROL MODULE?
In order to reset the eNEXHO-CR power-control module, press and hold the installation button for at least 4 seconds. The green
light indicator of the electronic board will ash to indicate that the module has been reset.
Please note that you have to congure the actuator in the eNEXHO system using the eNEXHO-NT internet module in or-
der to be able to use it. For that purpose, consult the chapter on how to power control modules in the home-automation
network of the NEXHO-NT manual.
If you have installed a eNEXHO-CR power-control module in a eNEXHO home-automation installation, once it is reset,
the detector will not perform the actions sent by the eNEXHO-NT internet module until you have re-congured it. To
re-congure it, please consult the manual of the eNEXHO-NT internet module and follow the steps described in the section on
how to install power-control modules in the home-automation network.