Operating Instructions and Installation Instructions
6
ASSEMBLY AND OPERATING INSTRUCTIONS | e NEXHO-CR – POWER-CONTROL MODULE
With your choice of ETHERMA you have decided on an inge-
nious heating solution. We thank you for your condence. In
us you have a competent partner with more than 30 years of
experience. ETHERMA relies on constant innovation , highest
product quality and modern design.
We support you with comprehensive personalized services and
nd the right product solution for you.
The following instructions will help you, to use your ETHERMA
quality product as effective as possible. They contain important
information about safety, installation, use and maintenance of
the devices. Please read the information in this instruction
carefully and keep them for feedback at a later time on.
GENERAL INFORMATION
TECHNISCHE DATEN
Consumption: ............................................P <1 W
Emission band: ...........................................f = 868 MHz
Power supply: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .100~240 VAC, 50/60 Hz
Max. allowed breaking power:...............................3.500 W
Dimensions (Height x Width x Depth): ........................34 mm x 50 mm x 42 mm
SPECIFICATIONS
WHERE SHOULD I INSTALL A e NEXHO-CR POWER-CONTROL MODULE?
INSTALLATION
The power-control module requires power cables to function
properly. Connect the wires to the corresponding terminals
using a screwdriver.
Make the necessary connections in the equipment, as shown in
the following diagram:
eNEXHO-CR equipment should be properly installed for full
functioning. This device should not be installed in locations
where it is exposed to humidity or liquid from water sprinklers.
Once properly wired, you can locate the equipment according
to your needs and convenience. Some convenient locations are,
for example:
› In a switch box, hidden behind a blank trim plate.
› In a junction box of the electrical installation.
› In a double ceiling.
› In a distribution board, where all electrical connections can
be centralised. The eNEXHO-CR power-control module is
provided with a hole on the lower side which enables the
connection of a xing screw for commercial DIN rail support
brackets.
NEVER connect switches to the mains 230-volt pow-
er line of your house.