User Manual

12 Setting Up
Connecting to a DVD Player
1. Check your DVD player to determine the type of cable to use:
■ The included shorter optical audio cable
■ An optional coaxial audio cable (not provided)
2. Connect the audio cable to the transmitter, then connect the other end to
your DVD player as shown below.
Note:
If you’re using the optical audio cable, remove the protective caps from both ends
of the cable. Then remove the protective cap from the transmitter’s OPTICAL
audio input port and store it in a safe place. You may also need to remove the
protective cap from the DVD player’s optical audio output port.
Note:
Use only one audio cable to connect the transmitter to your DVD player.
If you’re connecting to the optical audio output on your DVD player, you may need to
remove the protective cap from the DVD player’s optical audio output port. See your
player’s documentation for more information.
Optical Coaxial
Optical audio cable
Coaxial audio cable
DVD Player Transmitter
Joplin.book Page 12 Monday, September 18, 2006 2:43 PM