MSDS

Revision Date:11/19/13
Page 3 of 7
TTI 2-CYCLE WITH ETHANOL SHIELD
flammable below the product normal flash point.
NFPA Health Hazard
0
Flammability
1
Stability
0
Physical and Chemical Hazards
-
6. ACCIDENTAL RELEASE MEASURES
Personal Precautions Use personal protective equipment. Avoid contact with skin, eyes, and clothing.
Ensure adequate ventilation. If spilled, take caution, as material can cause surfaces to
become very slippery.
Methods for Containment Dike far ahead of liquid spill for later disposal.
Methods for Cleaning Up Pick up free liquid for recycle and/or disposal. Residual liquid and/or solid can be
absorbed on inert material.
Evacuation Procedures
Large Spill Consider initial downwind evacuate for at least 300 meters (1000 feet).
Fire If tank, rail car or tank car is involved in a fire, isolate for 800 meters (1/2 mile) in all
directions; also consider initial evacuation for 800 meters (1/2 mile) in all directions.
Reporting Requirements Spills that enter a water body must be reported immediately to the USEPAs National
Response Center at (800)424-8802. Check with your local and state regulators
regarding their reporting requirements.
7. HANDLING AND STORAGE
Handling Do not pressure, cut, weld, braze, solder, drill, grind, or expose such containers to heat, flame,
sparks, static electricity, or other sources of ignition; they may explode. See NFPA 30 and
OSHA 1910.106 flammable and combustible liquids.
Storage Store away from heat, sparks, open flame, or strong oxidizing agents in closed and properly
labeled containers. Empty containers retain product residue (liquid, and/or vapor) and can be
dangerous
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Guidelines
Chemical Name
ACGIH TLV
NIOSH IDLH
Petroleum Distillates,
Hydrotreated Heavy
Paraffinic
64742-54-7
5 mg/m3 8 hour(s). Form:
Mist
2,500 mg/m3
Petroleum Distillates,
Solvent Dewaxed heavy
Paraffinic
64742-65-0
5 mg/m3 8 hour(s). Form:
Mist
2,500 mg/m3
Aliphatic Hydrocarbons
64742-47-8
5 mg/m3 8 hour(s). Form:
Mist
2,500 mg/m3
Engineering Measures Additional area ventilation or local exhaust may be required to maintain air
concentrations below recommended limits.
Personal Protective Equipment
Eye/Face Protection Safety glasses with side-shields. If splashes are likely to occur, wear goggles.
Full face-shield to be worn during emergencies.
Skin and Body Protection As needed to prevent repeated skin contact. Solvent resistant gloves should