Unit installation

INTRODUCTION

ETERNITY G16/G20/G26

INSTALLATION INSTRUCTIONS

INTRODUCTION

The E I ERNTTY 16/20/26 is an external electronic gas hot water heater.

The ETERNITY 16/20/26 is supplied set at a constant 60°C outlet temperature

depending on the model purchased. Three optional remote controls can be

provided for complete hot water temperature selection and if this option is

used an approved temperature limiting device must be installed.

THIS HOT WATER UNIT IS NOT FOR

POOL OR SPA HEATING

GENERAL

1.0.1

The ETERNITY 16/20/26 must be installed in accordance with

(1)

These instructions;

(2)

Uniform Building Regulations Local authority regulations;

(3)

AS/NZS 3500.4"National Plumbing and Drainage Code, Part 4 Hot Water

Supply Systems",

(4)

The Australian Gas Association installation code AS5601 for gas burning

appliances and equipment;

(5)

Any other statutory regulation that may apply;

(6)

A notice of intention to install shall be lodged with the relevant Municipal

Authority and local Gas Authority prior to installation.

INSTALLATION MUST BE CARRIED OUT ONLY BY

AN AUTHORISED AND APPROPRIATELY LICENSED PERSON.

1.0.2

DELIVERY INSPECTION

The ETERNITY HOT WATER unit is supplied fully assembled for installation.

The customer or installer upon delivery of the unit should immediately remove all

packing materials and inspect the unit for damage and ensure that the unit supplied

is correct for the gas supply to which it is to be connected, report any damage or

discrepancies quoting to the supplier the serial number and model number, which

can be found on the outside of the cabinet.