Unit installation

FRONT COVER
WOOD SCREW
FRONT COVER
REMOTE CONTROL
METAL BRACKET
METAL BRACKET
ALTERNATIVES IN MOUNTING REMOTE CONTROLS
IN EITHER OF THE FOLLOWING TWO ALTERNATIVES, YOU ARE TO REMOVE METAL
BRACKET ATTACHED TO THE BACK OF EACH REMOTE BY SLIDING THE BRACKET
FIRMLY DOWN TILL IT IS RELEASED FROM THE NOTCH BY CLICK, THEN PULL IT
OUT.(MAIN CONTROL ONLY)
SINCE SHOWER/SUB CONTROLS WATERPROOFED, PLEASE INSTALL ON DIRECT
MOUNTING.
A. USING THE BRACKET (BEING REMOVED AS ABOVE) AS A FIXTURE:
(REFER THE DIAGRAM BELOW)
1.
FIX THE BRACKET TO THE WALL WITH WOOD SCREWS PROVIDED USING ANY
TWO HOLES OUT OF THE SIX HOLES PROVIDED TO THE BRACKET.
2.
FASTEN WIRING TO THE TERMINAL BLOCK.
3. FIX THE REMOTE CONTROLS TO THE BRACKET CATCHING THREE NAILS OF THE
BRACKET THROUGH NOTCH AND THEN SLIDING FROM ABOVE FIRM UNTIL IT
CATCHES THE NOTCH IN THE BRACKET AND CLICKS.
B. DIRECT MOUNTING
(REFER THE DIAGRAM BELOW)
1. REMOVE THE FRONT COVER OF THE
CONTROLS USING SCREWDRIVER
CAREFULLY EASING THROUGH THREE
SLOTS IN TURN PROVIDED AT THE TOP
OF THE CONTROLS.
2. FASTEN WIRING TO THE TERMINAL
BLOCK.(PLEASE SKIP THIS PROCESS IN
CASE OF SHOWER/SUB CONTROLS.)
3. FIX THE REMOTE CONTROLS BASE BY
WOOD SCREWS PROVIDED THROUGH
TWO HOLES AT THE BOTH SIDE OF THE
BASE. THEN FIT THE FRONT COVER IN
PLACE.
14