Datasheet

Page 30 of 36
I. General Information:
• Exit Setting: Enter * to exit the setting procedure, or wait for 10 seconds
• Low Battery warning: When the voltage drops below 4.8V, after entering a valid code, the red LED will flash and beep
five times.
• Unlock: Green light flashing twice and Beeps twice.
• Lock: Red Light flashing three times, and beeps three times.
• Reset: To set the lock back to default (123456), press and hold the reset button for about 10 seconds (3 beeps with LED
blink red). The reset button is located below the battery holder.
The reset button for the Eternity 4 is shown below.
The reset button for the Eternity 5 is shown below.
II. Manufacture Default Setting:
• Daylight Saving: Disabled
• Auto unlock/lock: Disabled
• Default Programming Code: 123456
• Lock Mode: Storehouse
III. Steps to setup a new lock (please follow the order)
1. Change programming code (For example, change to 247365)
# 123456 # 11 # 247365 # 247365 #
1. Enable daylight saving (optional)
# 247365 # 31 #
2. Set lock time (optional) (For example, set time as January 23, 2008, 2:45PM)
# 247365 # 88 # 0801231445#
3. Add user code (For example, add 1357 to the lock)
# 247365 # 01 # 1357 # # #
4. Add iButton key (Optional)
# 247365 # 01 # iButton key touch lock reader # #
5. Set schedule for user code or iButton key (see instructions below)
IV. Types to operate the lock:
• Keycode: User Code, #
• iButton: iButton key touch lock reader
• iButton+Keypad: iButton touch lock reader, LED grow green, enter user code, #
Eternity 4Reset
Button
Eternity 5 Reset
Button