Datasheet

Page 12 of 36
Step 6
Install batteries, and plug in the power
cable. Secure the back lock housing onto
the battery plate. Fasten with 2 screws.
Press both catch pin in and snap the rear
handle into drive shift (Fig 6)
Step 5
Attach the battery plate onto the door, with the
rubber gasket between the door and battery
plate. Make sure the power plug go through the
hole on the plate. Secure the battery plate to
front lock fastener post with 2 screws. Fasten
upper fastener post (Optional) (Fig 5)
Step 8
Put strike box in doorframe, and
then strike plate over it. (Fig 8)
Step 7
Place the override cylinder into front handle
housing, insert override key through the hole into
cylinder. Turn the override key 90° clockwise.
Press both catch pin in and snap the front handle
into drive shift. Turn override key 90° counter
clockwise and pull the key out. (Fig 7)
Fig 8
Fig 7
Fig 5
Fig 6