Datasheet

Page 11 of 36

Eternity-V-Installation

Step 1

Insert the latch into door

hole. Secure the latch with

two screws.

Step 2

Insert the square shaft (A) into the center hub (B) (Fig 1). Insert the position

pin into the hole on the center hub to secure the square shaft. Bend the end

of position pin around the center hub to secure the pin in place. (Fig 2)

Step 4

Place the front lock housing onto the door, with the

rubber gasket (E) between the door and lock housing.

Feed the power plug (F) through the hole (Fig 4).

Step 3

Screw in and tighten the two fastener extensions

both side of the center hub. Attach and tighten

the upper fastener extension (D) if needed (Fig

3). Note: The upper fastener extension (D) is

optional.

Fig 2

Fig 1

Enlarged

Fig 1

Fig 4

Fig 3

D (optional)