Specifications

 14,
L 1011
OKIVCX.LOC
FAN COVER
Fan
Heat sink
LED PCB
HEAD COVER
Fan support-
2.2 SETTING UP (MASTER/SLAVE)
When units are connected in seriesusing DMX512 signalcable connect the units
as shown inthe diagram below
•
Connect the (male)3 pin connectorside of the DMX cable to the output (female)3
pin connector ofthe first (MASTER) fixture.
•
Connect the endof the cable coming from the MASTER fixture whichwill have a
(female)3 pin connector to the input connector ofthe next fixture consisting of a
(male) 3 pin connector.
*Then proceed toconnect from the output as statedabove to the input of the
following fixture andso on.
*Set the firstunit in theseries to on e of the STAND ALONE modes as de scribedin
section 2.2
•
All other unitsin the series should be setto <SLAVE> from the <operation> menu.,
2.3 SETTING UP (DMX512 CONTROLLER)
When units are connected
in series to
a DMX512 controller
and
other
DMX512 equipment, connect the equipment as shown in the diagram
below.
*Connect the (male)3 pin connectorside of the DMX cable tothe output
(female) 3 pinconnector of the controller.
•
Connect the end of the cable coming from the controller which will
have a (female)3 pin co nnectorto the input connector of the next fixture
•
consisting of a(male) 3 pm connector.
Then proceed to connect from the output as stated above to the input of
the following fixture an d so on.
•
lf over 32pcsfixtures connected ,the amplifier is needed.
2 INSTALLATION
2.4
LED PCB REPLACEMENT
•
Take off the head cover.
•
Remove the fan cover, fan, fan supports, heat sink step bystep
.
•
Replace the new
LED PCB.
•
Install all parts on the original position.
2.5
GOBO REPLACEMENT
•
Unlock the gobocover
;
•
Take out thetarget rotating gobo.
•
Install the newrotating gobo, lock thegobo slot door.
•
0130 SLOT DOOR
2 INSTALLATION

0