User manual

Work time
Total Operating Time
Battery Capacity
Battery Percentage Indicator
LCD Display time
Full on
10s/11s/12s…60s
IR INFA
Enable/Disable
Menu:
• Start Up – Welcome to Eternal Lighting Screen
• Switch to Display- When blinking, choose Program RGBWA or RGBWA+UV, press
UP and Enter
• DMX Address and Channel Mode – Press Enter to move up and down between
DMX Addr and CH also press Enter to save a command.
• Master/Slave – Press Up or Down to change the command of Master or Slave, Enter
to save the command. (NOTE: In order to use the IR Remote, put in Master Mode.
The fixture will not respond to the IR Remote if it is in Slave Mode.)
• Manual – Press Enter to go through Red, Green, Blue, White, Amber, & UV. Press Up
or Down to adjust color brightness on a scale of 0-255. This will act like your Master
Dimmer.
• SHND –Press Up to scroll through options: Color, Sound, and Fade. Enter to select
choice.
o Color – Pre-set colors 1-50, after color 50 is AUTO change (Speed 1-8). After
AUTO, is Custom Color A – E; Enter make a custom color. You can make 5
custom colors that will be saved under A through E.
o Sound – Sound 1 (auto change when hears sound & Fade when quiet). Sound
2 (Strobe effect when hears sound & Fade when quiet).
o Fade – Color Fade 1 through 10. Fast (1) to slow (10).
• Boot Time and Work Time – Current operating time and total run time
• Battery Capacity – (Non Active Feature on EliteParHEX as no battery in this light)

• LCD Display Time – Press Up to adjust 10 sec to Full On Display Back Lit Light
• IR INFA – Enable or Disable
5
EliteParHEX RGBWA+UV Manual Eternal Lighting July 2014