User manual

 Add: To add an IP QoS session, place a check at the Enable IPQoS then click Add button. The
following screen will pop-up.
 Rule Name: Enter the IP QoS session name.
 Source IP: Enter the Source IP Address.
 Source Netmask: Enter the Source IP Subnet Mask.
 Source Start Port: Enter the Source IP Start Port which PPP session can be activated.
 Source End Port: Enter the Source IP End Port which PPP session can be activated.
 Destination IP: Enter the Destination IP Address.
 Destination Netmask: Enter the Destination IP Subnet Mask.
 Destination Start Port: Enter the Destination IP Start Port which PPP session can be activated.
 Destination End Port: Enter the Destination IP End Port which PPP session can be activated.
 Protocol: Select the protocol from the drop down manual. The protocols supported are TCP, UDP,
ICMP and ANY.
 Physical Port: Select the QoS Physical Port from the drop down manual.
 Traffic Priority: Click and select the QoS session Traffic Priority from the drop down manual.
 TOS Marking: Place a check at the Normal Service or select the TOS Marking from the list.
 Apply: Click the Apply button to confirm your setting.
 Cancel: Click Cancel to ignore all the changes.
 Save All: To complete and save the setting, click Save All after clicking the Apply button.
4 Ports ADSL2/2+ Router 67