User manual

4 Ports 11g Wireless ADSL2/2+ Router 35
4.3.1 CONFIG - WAN Setup
WAN Setup: The WAN configuration page allows you to set the configuration for the WAN/ADSL ports.
ADSL connections can be configured in a variety of ways depending on the ISP/WAN configuration, and the
requirements of your home or office LAN. This 4 Ports 11g ADSL2/2+ Router supports the following ADSL
connection types:
; PPPoE (RFC2516)
; PPPoA (RFC2364)
; DHCP
; Static
; Bridged (RFC1483)
; CLIP (RFC1577)
Configuring the 4 Ports 11g ADSL2/2+ Router to match these connection types may require entry of some or
all of the following values:
; ISP Account Username and Password
; VPI/VCI Setting
; Encapsulation Type/Multiplexing ( Either LLC or VC, check with your ISP for details )
; ADSL Handshaking Mode ( Default setting is MMODE )
; Network Settings for Bridged Mode operation:
For PPPoA or PPPoE users, you need the following values from your ISP:
; Username
; Password
For Bridged Mode connections (RFC1483), you need the following information from your ISP:
; DSL Fixed Internet IP address
; Subnet Mask
; Default Gateway IP Address
; Primary DNS IP address.
The next sections will describe in detail how to set up each of these connection types and save them as
Connection Profiles.