Owner's manual

6 CEM3 Sensor+ Rack Retrofit Manual
Attach New Power Harness
Step 1: Connect the old power connector to the new power harness adapter found in the
kit. The connectors are keyed - the power connectors only fit one way.
Step 2: Run the green ground wire from the power harness adapter between the bus bar
and the rack wall avoiding any interference with other wires in the rack.
Step 3: Carefully route the ground wire to any open terminal in a grounding strip inside
the rack. Grounding terminal screws can be loosened or tightened with a flat-
blade or square drive screwdriver.
Step 4: Use a wire tie to secure the ground wire to the wires that travel from the mated
power harness connectors.
New Power Harness