Owner manual

8 CEM3 Sensor+ Portable Pack Retrofit Manual
Remove the CEM+ Backplane
Step 1: Remove the lid retaining bolts using a wrench (may be 7/16” or 3/8” depending
on your pack model). The bolts are found at the top of each side of the pack, just
beneath the lip of the carrying handles.
Step 2: Raise the lid from the data connection side to expose the CEM+ backplane.
Step 3: Disconnect the multi-colored DMX ribbon cable and CAT5 cable from the
backplane.
Step 4: Remove the lid entirely to expose the inner cavity of the pack.
Step 5: Disconnect the power wire harness and dimmer output cable from the backplane.
Step 6: Remove the backplane screws found at the top corners on each side of the
backplane using a #2 phillips screwdriver.
Step 7: Bend in the side arms of the backplane and remove the CEM+ backplane from
the pack.
Up
Side View of Pack
Disconnect these from Backplane
DMX
Ethernet Power
Dimmer Output
Remove these screws