User Manual

14 CEM3 Sensor+ ESR+ Rack Retrofit Manual
source is not present.
Configure the CEM3
Step 1: Configure the rack to reflect the dimmer module types installed. Verify that the
rack type is correct (CEM3 should have determined this from the DIP switch
settings - see Backplane Settings, page 11). Configuration of the CEM3 is done
using the front face panel interface. See the CEM3 Quick Guide that ships with
the CEM3 for more information.
Step 2: Configure the data types that will be used (DMX and sACN) including the rack
patch.
This concludes the retrofit procedure.
Note:
When first booting, CEM3 may upload firmware into the AF2 cards. This may take
10 minutes or more and is normal for a firmware update.