Specifications

ETC Release Note:
Eos/Ion Software v1.4.0
Eos/Ion v1.4.0 Release Note Page 9 of 10 Electronic Theatre Controls, Inc.
2471 Inhibitive Subs are always recorded even when selected to be excluded.
Known Issues Remaining in v1.4.0
4148 In the About display, Patch tab, selecting an Address is re-patching your fixture.
Workaround: Do not use About Address in patch mode
4047 [Assert] + [Load] does not work with subs
4044 ION Client, Information line is not reflecting the correct state of the desk when there is no Master.
4041 RPU does not boot with a 15 inch VGA monitor connected
Workaround: Boot the RPU without the monitor connected, then connect after boot has completed.
4039 Macro wait for input state, missing message above command line about [Escape] to cancel.
4035 Select button misbehaving in custom fixture editor
4032 Time code events reappear after deleting
4030 Loading an inhibitive sub to a fader does not move the pot to full
4014 First and Last Selections Have An Incorrect DMX Value on Continuous Wheels
Workaround: Tweak values via encoder or command line
4011 Flexi View Channels not saved with show file
3998 Lightwright Ascii files not importable unless you give it a file extension of .asc
3987 Unable to Display Group with many channels
3985 [Channel] [1] [at] [0] [enter] and [Channel] [1] [at] [enter] unpatch part 1 only
3981 [1][Focus][Pr1][Pr2] should set only focus parameters
3974 Undo leaving references in background levels
3973 [Clear] when entering a label clears more than last character
3907 Lost control of intensity on the level wheel
3870 In a multiconsole system About Eos does not display the correct channel count for the system
3863 Backup can incorrectly display “tracking” above the command line
3825 Can’t use virtual controls to load a sub.
3823 Cue delay time does not apply to an effect
3814 Some displays not restored by persistent storage
3796 Macro wait displayed incorrectly above command line
3786 Background levels as off states in effect snap to their new levels in cue transitions
3781 Cannot undo wheel events (level wheel, encoder, etc)
3742 Fixtures with a “White” parameter cause jump in color picker
3730 With 3 monitors, expanding a tab to the right from M2 expands to M1
3727 Moving a single part of a part cue to a whole cue is incorrect
3712 On Ion, clicking [Data + Category] turns off the filter button, but not filter mode
3688 Using Link Local address results in application starting before address assigned
3674 If Master hangs, there is no indication on backup
3624 Snapshot always restore virtual fader modules to page 1.
3623 Snapshots will not recall virtual controls to the LCD’s, if direct selects are open
3592 Virtual A/B faders don't work with split fades
3581 Cannot un-park channels that are not in your partition.
3578 Channels above the number of channels in setup are being displayed.
3557 Backing out of a manual cue does not reset fader
3556 Manual up/down fades should split when both faders reach zero.
3547 Blackout button does not register in macro editor
3544 Able to connect two Backups to Eos.
3530 In Flexi-Show channels in the table view, selecting last channel hides others
3523 Using keyboard shortcuts, can not double press record target to open lists.
3486 [Fader Controls] and encoder movements should be ignored by macros
3455 EOS always subscribes to MIDI System Exclusive In
Issues Corrected in v1.4.0 [Continued]