User Manual

14 HQ-100 Performance Hazer User Manual
Manual Mode Menu
When you are not using DMX control, you must manually set the output values for the hazer.
Tap the up and down arrow buttons to set the values. The settings remain active until you either
manually change them or you enable DMX control.
Parameter Value Description
HAZE 0–100
Haze mode produces a continuous output of haze. A setting of 100
produces the maximum amount of haze the HQ-100 Performance Hazer
can output continuously.
Note: At a setting of 100, the hazer uses a maximum of 5ml (0.17oz)
of haze fluid per minute.
BLOWER 1–100 Control the speed of the blower: 1 is the lowest setting.
HO ON/OFF
High output (HO) mode is a non-continuous haze mode. When HO is set
to "ON", the HQ-100 Performance Hazer outputs the maximum amount
of haze it is capable of producing for as long as it can. As necessary, the
hazer will pause to allow the heating element to cool.
Note: The HO mode uses 12ml (0.41oz) of haze fluid per minute.
Set Up Wireless DMX Control
The HQ-100 Performance Hazer includes an internal 2.4GHz City Theatrical Multiverse
®
DMX
receiver. You can use a City Theatrical Multiverse transmitting device to wirelessly configure
and control the hazer. For information about using Multiverse products, see the documentation
provided with the products.
Note: For additional guidance and troubleshooting resources, download the
Multiverse Wireless Setup Information Guide from etcconnect.com.
To use wireless DMX control, configure the wireless DMX settings on the hazer.
1. Tap the SETTINGS button to open the SETTINGS menu.
2. Tap the WIRELESS DMX button.
3. Tap the ON/OFF switch to turn on the DMX receiver. The signal strength is shown.
4. Tap the SETTING button.
5. Tap the up and down arrow buttons to set the Universe, SHoW ID, and SHoW Key values.
These values must match the values of the Multiverse DMX transmitter with which the
hazer will communicate.