User Manual
Table Of Contents
Mount the Hazer 9
Mount the Hazer
WARNING:
•
Do not use outdoors. Indoor use, dry locations only. Intended for use
where humidity does not exceed 95% (non-condensing).
•
Do not suspend directly above an audience or performers.
•
Install only in a well-ventilated area.
•
Do not install on a flammable surface or near flammable materials or
gases.
•
The installation location must support a minimum point load of
10times the weight of the hazer.
•
The installation hardware must be capable of supporting a minimum of
10times the weight of the hazer.
•
The installation must always be secured with a secondary safety
attachment. A safety cable is not supplied.
•
Safety cable attachment must be rated by a safety factor of 10.
•
Any clamps you use for installation should comply with, and be
approved by, the Authority Having Jurisdiction (AHJ).
•
Never stand directly below the installed hazer when mounting,
removing, or servicing the hazer.
•
All safety and technical aspects of hazer installation must be approved
by a qualified personnel before operation.
•
Overhead rigging must be performed by qualified personnel.
CAUTION:
Follow all local codes and recommended practices by the
Authority Having Jurisdiction. The installation must only be carried out by
qualified personnel.
When mounted, the hazer must be level and its feet must be directed downward. You can set
the hazer on the floor or another supportive, stable, flat surface, or you can suspend the hazer
by the yoke using appropriate mounting hardware. If you suspend the hazer, make sure to
secure the hazer with an appropriate safety cable at the safety cable attachment point. The
safety cable and mounting hardware are not supplied with the HQ-100 Performance Hazer.