User Manual

Assemble the Hazer 7
Assemble the Hazer
Attach the Haze Fluid Hose
The haze fluid hose is included in the accessories bag.
1 3 42
1. Unscrew the round attachment nut from the hose connection point on the top of the
hazer.
2. Feed the open end of the haze fluid hose through the top of the attachment nut.
3. Fit the open end of the hose over the nozzle on the top of the hazer.
4. Slide the attachment nut down the hose to the connection point, and tighten the nut to
secure the hose in place.
Connect the Fluid Tank
The HQ-100 Performance Hazer ships with an empty fluid tank installed in the hazer. Install a
full fluid tank before use.
WARNING: HQ-100 Haze Fluid has been specifically designed for use in
the HQ-100 Performance Hazer. The haze fluid has been tested for use by
independent toxicological laboratories and found to be non-toxic. The use
of other haze fluids that may not take into account the specific evaporation
system, temperature, flow rate, and materials used to construct the HQ-100
Performance Hazer may be construed as a health hazard and will void the
product warranty.
WARNING: Do not dilute HQ-100 Haze Fluid. Diluting the haze fluid with
water, scents, or other additives could damage the hazer and create health
and fire hazards.
1. Remove the empty fluid tank from the hazer.
2. Remove the tank filter cap from the empty fluid tank.
3. Verify that the two hoses are securely attached to the inside of the tank filter cap.
4. Screw the tank filter cap onto a full fluid tank.
5. Place the full fluid tank into the hazer. Orient the tank so that the tank filter cap is near
the haze fluid hose.