Owner manual

304 Eos Titanium, Eos, and Gio Operations Manual
{Device Details} - appears when the current address is patched to a RDM device. RDM devices
must be enabled through the ECU and discovered through the patch. See RDM, page 373, Display
Pages in Patch, page 100, and Errors and Warnings, page 110.
{Device Details} displays the information that it receives from the device and allows some changes
to be made to:
• Device Label (displayed at the top by the address number)
• DMX Address (can be changed in this display by clicking on the property or value)
• DMX Label (same as the device label, but the label can be changed here by clicking on
the property or value)
• Type
• Manufacturer
• Device ID
•Footprint
• Version
• Lamp State
• Lamp Hours
• Head DC Voltage
• Lamp On/Off
• Gel Distance Traveled
• Gel2 Distance Traveled
•Fan RPM
• Ambient Temperature
• Gel Temperature
• Device Errors (will only display if there are current errors)
• Clear Errors
Device Errors are displayed in four different colors depending on severity.
• Gray - unknown or not an error
• White - Advisory
• Yellow - Warning
•Red - Error
Note:
Changes may take a few seconds to make. They will propagate to the RDM device
and then back to the console’s patch and about displays.
Note:
Changing the address can not cause any part of the fixture to move to a different
universe or communication with the device may be lost. The universe is set into
the gateways port configuration.
Note:
Details displayed will vary based on the device.
Note:
Color severity is determined by the device manufacturer.