Owner manual

23 Using About 303

{Dimmer Feedback} - appears when the current address is patched to a dimmer in an ETC Sensor

rack with a CEM+ or CEM3. Sensor feedback must be enabled. See Sensor Feedback, page 373

and Errors and Warnings, page 110 for more information.

{Dimmer Feedback} displays the following information:

• Name (dimmer name)

• Module type

• Rack/Position

• Rack dimmer level (displayed as a percentage)

• Rack dimmer source

• Recorded load

• Actual load

{Dimmer Feedback} displays the following information, which can be modified from Eos by clicking

on the value and entering in a new value:

• Firing Mode

• Control Mode

•Curve

• Threshold

• Scale Minimum

• Scale Maximum

• Preheat Enable

• Preheat Timing

• Advanced Features (AF) Enable

Eos support the following softkey commands from this display:

• {Ignore Errors}

• {Clear Errors}

Note:

For Sensor feedback, the CEM+ must be running software version 3.0 or later.

Note:

Clearing CEM+ or CEM3 errors from Eos will be temporary unless the errors have

been fixed at the CEM+ or CEM3. Errors displayed on Eos will clear on their own

once they have been cleared from the CEM+ or CEM3. Some CEM+ or CEM3

errors can only be cleared at the CEM+ or CEM3.