Owner manual

172 Eos Titanium, Eos, and Gio Operations Manual
Storing Palettes to Direct Selects
You can store palettes efficiently using the direct selects. Rather than using the [...Palette] hard key
and the numeric keypad to specify a palette number, you can simply touch the desired direct select
for that palette from the touchscreen.
For Example:
If you want to store color data to color palette 4, press:
•[Record]
and then press the button in the bank of color palette direct selects that is labeled in the
lower right corner with a light gray “4”.
•{Color Palette Direct Select Button 4}
“Color Palette 4” will appear in the direct select, indicating a successful store.
For more information on direct select mapping, see Using Direct Selects, page 45.
Using Filters with Palettes
Filters can be used to modify what data is stored to a palette by a record action. The parameters
that are active or filtered allow those parameters to be stored to record targets.
To filter a parameter:
Step 1: Press and hold the [Filter] button on the face panel.
Step 2: In the CIA, press the touchbutton for the parameter you wish to store.
Step 3: Release the [Filter] button. “Filter On” appears next to the parameter category button.
To determine which parameter is filtered in the category:
Step 1: Press and hold the [Filter] button. All actively filtered parameters are highlighted in
gray. You may need to press the arrow softkeys for that parameter category to page
additional parameters in the category.
Filters are a toggle state. To remove filters, press and hold [Filter] and press the highlighted
parameter buttons in the CIA to deactivate the filters, or use {Clear Filters}.
For more information on filters, see Using Filters, page 227.