Tus neeg siv phau ntawv

ETC Installation Guide
ColorSource PAR v1.7/v3.0
Change the DMXControl Mode
You can set the DMX control mode for the fixture to one of four available
mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the
Mode button for 3 seconds. The display shows the
current DMX control mode.
3. Press the Up button or Down button to change the DMX control mode.
•
5ch: 5-channel mode (intensity, red, green, blue, and strobe). This is
the default mode.
•
dir: Direct emitter control (intensity, red, green, blue, indigo, lime, and
strobe).
•
1ch: 1-channel mode controls the intensity of preset 1 (defaults to
3200K White).
•
rgb: RGB mode (red, green, and blue).
4. Press the
Mode button to confirm your selection.
The display will automatically return to the DMX address after 10 seconds of
inactivity, and edits to the DMX control mode will not be saved. This cancels
unsaved changes.
DMXControl Channels
DMX
Channel
5ch
(5 channel)
dir
(Direct)
1ch
(1 Channel)
rgb
(RGB)
1 Intensity Intensity Intensity Red
2 Red Red Green
3 Green Green Blue
4 Blue Blue/Indigo*
5 Strobe** Lime
6 Strobe**
*Original ColorSource PAR fixture uses blue in channel 4; Deep Blue fixture uses indigo in
channel4.
**Use DMX values of 0 or 255 for no strobe. Use values of 1–254 to increasethe strobe rate
from 1 per second up to 33 per second.
ColorSource PAR Page 7 of 16 ETC