Tus neeg siv phau ntawv

ETC Installation Guide
ColorSource PAR v1.7/v3.0
4. Press the
Mode button to start the update process.
•
The display alternates between Udt and the percentage complete while
updating.
•
The display blinks once to indicate that the update is complete.
5. Reconnect DMX In on the fixture.
Restore Factory Defaults
Press and hold the
Mode button, Up button, and Down button
simultaneously for 5 seconds. The DMX start address will blink once to
confirm that defaults have been restored.
Error Codes
There are three error codes that may be shown on the user interface.
•
CAL: Screen toggles between CAL and Err to indicate a problem with
the color calibration. The fixture will need to be returned to the ETC
factory; contact your local dealer to set up a repair.
•
OtP: Screen toggles between OtP and Err to indicate that the fixture
has gone into over-temperature protection mode to avoid damaging the
fixture. Once the fixture has self-cooled, the error will automatically clear.
•
No App: Screen toggles between no and APP to indicate that the
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC (visit
etcconnect.com/contactETC).
ColorSource PAR Page 12 of 16 ETC