Tus neeg siv phau ntawv
Table Of Contents
ETC Installation Guide
ColorSource PAR v1.7/v3.0
Troubleshooting
Update the Fixture Software
ETC recommends using UpdaterAtor software to manage software updates.
For information on UpdaterAtor, see the
UpdaterAtor Software Quick Guide
and the
UpdaterAtor Software ReleaseNote
, which you can download from
etcconnect.com.
You can push newer software versions from a connected fixture to selected
ColorSource fixtures(see table that follows). You can push newer software
versions from a connected fixture only on ColorSource fixtures running
software v1.3.0 or newer. Use UpdaterAtor to update individual fixtures
running versions older than v1.3.0.
Note:
If you have other types of fixtures in your DMX run, you do not
need to disconnect them before pushing the updated fixture
software. The update process will ignore any other fixture types in the
DMXrun.
Note:
Not sure what version of fixture software is installed?The
version number appears on the display when the fixture powers up.
This fixture... ...can push software to these fixtures/releases when connected
CYC Linear PAR Spot Spot jr
≤ v1.7 ≤ v1.7 ≤ v1.7 v3.0 ≤ v1.7 v3.0 v2.0
CYC v1.7 or earlier X X X X
Linear v1.7 or earlier X X X X
PAR v1.7 or earlier X X X X
PAR v3.0 X X
Spot v1.7 or earlier X X X X
Spot v3.0 X X
Spot jr v2.0 X
1. Remove power and DMX In from the fixture that is running the software
version that you want to push to other fixtures.
2. Press and hold the
Up button and Down button simultaneously while
restoring power.
3.
The display shows
Udt rdy to indicate the update mode is selected.
ColorSource PAR Page 11 of 16 ETC