Tus neeg siv phau ntawv

ETC Installation Guide
ColorSource PAR v1.7/v3.0
Re-record Presets
1. Using DMX, set the desired levels for the new preset.
2. Press the
Mode button to access the Presets/Sequences menu.
3. Press the Up button or Down button to navigate to the preset number
that you want to re-record.
4. Press and hold the Mode button for 3 seconds to confirm the preset
selection. The user interface will show a 3-second countdown. The preset
number blinks once to confirm that the preset has been recorded.
Note: When the fixture is in Direct mode (dir) or 1-channel mode
(
1ch), you cannot re-record presets.
When you re-record presets with the fixture in RGB mode (
rgb), the
intensity is set to full and the strobe is turned off.
See
Change the DMXControl Mode on page7.
Adjust the Intensity of Presets
1. Ensure that DMX data is not present.
2. Press the
Mode button to access thePresets/Sequences menu, and then
press the Up button or Down button to select the preset that you want to
edit.
3.
Press and hold the
Mode button for 3 seconds. The display shows L:
followed by either an intensity level from 0– 99 or FL for full.
4. Press the
Up button or Down button to change the intensity level of the
preset in real time.
5. Press the Mode button to confirm your selection and return to
thePresets/Sequences menu.
The display will automatically return to thePresets/Sequences menu after
10seconds of inactivity, and edits to the preset intensity will not be saved.
ColorSource PAR Page 10 of 16 ETC