Manual

Cobalt 7.1 - 20140612
976
Remote Control - Introduction
There are a number of options for remote controlling a Cobalt system.
There are three main kinds of wireless remote controls.
RFR Phone Remote iRFR
The RFR Radio/USB
Remote is equipped with
a display and bi-
directional
communication.
A wireless phone can be
connected to the RJ11
connector in the back and
be used for basic remote
functions.
iRFR is a software for
iPhone and iPod that
provides bi-directional
communication over a
wireless LAN.
NOTE
To clear input from the Remote Fields go to the Clear Remote Fields node in
the Remote Controls Node.
See Remote Controls.
Remote Control are enabled in the System Settings for remotes to work.
There is a specific setting to enable recording from the Remotes. Both are ON
by default.
See System Settings - System.
Remote Controls and at mode
If your console is set to operate channels in at mode, the remote will also function in at mode. See
System Settings - General
and Channels - Command Syntax.
HINTS
• 100%/0%/+%/-% will now complete pending at mode operations.
• C will abort pending two-digit level entries.
• Decimal point will complete pending at mode operations without pressing @.