Manual

Cobalt 7.1 - 20140612
196
Standard MIDI
All keys and faders can send notes and controllers when this is activated in the MIDI Settings.You can
use MIDI notes and controllers to remote control any key or fader of the Console.The Cobalt can also
be set to activate a specific crossfade when receiving a Program Change command through MIDI. See
MIDI
.
Function Explanation Default value
Direct mode Midi Direct Mode On
MIDI Channel The MIDI channel used by Cobalt 1
Keys All keys are sent as notes. Off
Faders All faders are sent as controllers. Off
Program Change Jumps to sequence step # -
MIDI Show control
Cobalt supports sending and receiving of MIDI Show Control (MSC) commands. See MIDI - MIDI
Show Control.
Function Explanation Default value
Enable Activates reception of MSC. Off
Device ID Sets a Device ID for this Cobalt. 1
Time Code
Every sequence step can be triggered both manually, and by a specific MIDI Time Code time on the
MIDI port. See MIDI - Time Code
.
Function Explanation Default value
Time Code MIDI Times Code reception is on. Off
Learn mode Activate learn mode for setting
Time Code to Sequence Steps.
Off
Auto-locate step Sets if Time Code should auto-
locate steps or not.
Off
Enable Backup clock Enables the backup clock Off
Internal clock start Sets a start time for the internal
clock.
--.--.--.--