User Guide

ETC Quick Guide
Desire Fresnel
Desire Fresnel Page 7 of 8 ETC
Use Fixture in Stand-aloneMode
After you connect power to the fixture, press the
Function button ( ), use the Intensity encoder
to navigate to one of the following stand-alone modes, and then press the Intensity encoder to
select it:
•
Studio: Use one of three studio (white light) presets, or customize the presets.
•
Color: Use one of 12 color presets, or customize the presets.
•
Effects: Use a sequence, or customize a sequence.
•
Preset: Use one of 12 presets (color preset + fade time), or customize the presets.
The colors of options on the display correspond to the colors of the encoders below the display
and the Intensity encoder to the right of the display. Turn an encoder to modify the corresponding
value on the display, or press an encoder to activate the corresponding option at the bottom of
the display. Press the Intensity encoder to toggle between the current intensity and 0%.
If the fixture is connected to other Desire Fresnel fixtures that are in the same stand-alone mode,
the connected fixtures will play the same preset or effect.
Select a Color Temperature
1. Press the Function button ( ), use the Intensity encoder to navigate to Studio Mode, and then
press the Intensity encoder to select it.
2. Press the color encoder that matches the studio preset you want to use (Blue = 3200K, Green=
4500K, Red= 5600K).
More Options
•
Turn off the preset: Press the Intensity encoder to toggle the intensity value from the current
value to 0. Press the Intensity encoder again to toggle back to the previous intensity value.
•
Modify the preset:Turn the encoders to change the corresponding values. For example, turn
the Intensity encoder to change the intensity value, or turn the blue encoder to change the
color temperature value.
•
Int + 1/4 Stop
Modify the intensity:Turn the Intensity encoder to adjust the
intensity, or press and turn the Intensity encoder to adjust the
intensity by 1/4 stop.
•
Tune 0.3 Metamer
Modify the tuning:Press and turn the red encoder to change the
value to Metamer, and then turn the red encoder to change the
Tune value (the "recipe" of the metamer). Press and turn the red
encoder again to return to the Brightest or Spectral options.
•
Revert to the original preset:Press the encoder that corresponds to the preset again to restore
the original values.
•
Save the modified preset:Press and hold the encoder that corresponds to the preset that you
want to re-record. The display shows a three-second countdown before re-recording the
preset.
Select a Color
1. Press the Function button ( ), use the Intensity encoder to navigate to Color Mode, and then
press the Intensity encoder to select it.
2. Turn the encoders to change the corresponding values. For example, turn the Intensity encoder
to change the intensity value, or turn the green encoder to change the hue value. The
crosshairs on the display indicate the approximate color.
You can use a preset as a starting point for a color by pressing the color encoder that matches
the preset. Turn the red encoder to move to another page of presets.