User Guide

ETC Quick Guide
Desire Fresnel
Desire Fresnel Page 5 of 8 ETC
Connect Power and Data
1. Attach five-pin XLR cable to the DMX In connector (if using external control).
2. Plug the XLR cable (if using) into the DMX source or data daisy-chain.
3. Use the DMX Thru connectors to connect up to 32 device loads on the DMX daisy chain.
4. Use the Power Thru connectors to connect other fixtures using the following recommended
guidelines.
•
Power Thru: Link up to 9fixtures (14A max) via Power Thru connector when using an R20
Relay Module (consult breaker-trip curves when using other equipment).
5. Attach the power cable to the Power In connector, and then plug the power cable into
ACpower (100–240VAC, 50/60 Hz) on a non-dimmable circuit.
Focus the Fixture
1. Apply power to the fixture, and wait until the fixture has booted up(the ETC splash screen
displays during boot up).
2. Press any encoder to "wake" the display.
3. What screen is currently displayed?
•
DMX:Press any encoder to leave the view-only screen, and then press the Intensity encoder
to turn on the LED array. The display shows a timeout countdown to indicate how long the
LED array will remain on at 100% intensity. You can turn the Intensity encoder to reset the
timeout countdown to 5minutes.
•
All other screens (Studio, Preset, etc.): Press the Intensity encoder to turn on the LEDarray,
and turn the Intensity encoder to adjust the intensity.
4. Adjust the fixture to the desired position.
5. Rotate the zoom knob on either side of the fixture to adjust from spot to flood.
6. Press the Intensity encoder to turn off the LEDarray.