User Guide

ETC Quick Guide
Desire Fresnel
Desire Fresnel Page 3 of 8 ETC
Safety
WARNING: RISK OF ELECTRIC SHOCK! The light source in this luminaire is not
user-replaceable, and must be replaced only by a qualified technician. Contact
ETC Customer Support for assistance.
AVERTISSEMENT : RISQUE DE DÉCHARGE ÉLÉCTRIQUE! La source lumineuse
de ce projecteur n'est pas remplaçable par l'utilisateur et ne doit être remplacée
seulement par un technicien qualifié. Contactez le service client ETC pour obtenir
de l’assistance.
WARNING: Note the following safety warnings before use:
•
Use the fixture in dry locations only, where humidity does not exceed 90
percent (non-condensing).
•
Connect the fixture to a non-dimmable power source in order to avoid
damage to the fixture's internal power supply and other electrical
components. Using a dimmable power source can damage the fixture and
will void the warranty.
•
Disconnect the fixture from power and DMX and allow it to cool before
installing accessories or performing any cleaning and maintenance.
•
Only use mounting hardware that is rated for the total weight of the fixture
and accessories.
•
When the fixture is mounted, the axis between the yoke attachment points
must be parallel to the ground. Mounting the fixture in a non-parallel
orientation risks property damage or bodily injury.
•
In addition to primary suspension, attach a safety cable (or other approved
safety device) to the fixture. Safety cables must be rated to support ten
times the fixture weight. Consult local standards to ensure that safety cables
meet all requirements.
•
Check that the accessory holder is locked and that any accessory safety
cables are connected before mounting the fixture.
•
Do not operate the fixture without the lens installed.
•
Do not use this fixture with a damaged power lead. If the power lead (cord
set) is damaged, it must be replaced.
•
Do not use this fixture if the lens is deeply scratched or cracked. You must
replace the lens when it is damaged.