User's Manual

User Manual 21
Rotate the Lens Barrel
1: Unlock the rotating barrel lock using
the 2 mm Allen wrench (provided).
2: Rotate the barrel to the desired
location.
3: Lock the rotating barrel lock using the
2 mm Allen wrench (provided).
Use the Integrated
Media Holder
The Irideon FPZ comes equipped with an integrated media holder, which is a
metal frame used to hold color media (often referred to as gel) or diffusion in
front of the lens. The media holder is equipped with a magnetic retaining clip
that prevents the media from falling out. The integrated media holder can take
color media, diffusion, or dichroic glass with a 2.6” (66 mm) diameter.
Install Color Media or Diffusion
1: Release the magnetic retaining clip by
gently pushing it up.
2: Insert the media.
3: Replace the media holder by aligning
the tab at the top of the media holder
with the inset on the front casting.
Install Dichroic Glass
The integrated media holder
accommodates 1.75 mm-thickness
dichroic glass.
1: Release the magnetic retaining
clip by gently pushing it up.
2: Place the dichroic glass into
the groove.
3: Replace the media holder by
aligning the tab at the top of
the media holder with the
inset on the front casting.
WARNING:
Make sure the media holder is locked in position with the
magnetic retaining clip.
Rotating
barrel
lock
Magnetic
retaining
clip
Integrated
media
holder
Dichroic
glass
Orange
rubber
pads
Magnet