User's Manual
Table Of Contents
- Introduction
- Specifications
- Basic Assembly
- Installation
- Adjustments
- Clean the Lens
- RDM Values
User Manual 19
Adjustments
Set the Angle with the
Yoke
1: Loosen the yoke locking knob.
Do not remove the knob.
2: Tilt the fixture to the desired
position.
3: Tighten the yoke locking knob
to secure the position.
Zoom and Focus the
Beam
1: Loosen the beam focus or zoom knob located under the barrel. Do not
remove either knob.
2: Slide the lens forward or backward to achieve the desired beam edge
or angle.
3: Once the fixture is focused, tighten the knobs.
Yoke
locking
knob
Beam focus
knob
Zoom knob