User's Manual
Table Of Contents
- Introduction
 - Specifications
 - Basic Assembly
 - Installation
 - Adjustments
 - Clean the Lens
 - RDM Values
 
2 Irideon FPZ
WARNING:
Please note the following safety warnings before use:
• Do not mount the fixture on or near combustible 
surfaces.
• Do not operate the fixture without a lens installed, or 
with a scratch or cracked lens. Damaged lenses must be 
replaced.
• Use in dry locations only, where humidity does not 
exceed 90 percent (non-condensing). These fixtures are 
not intended for outdoor use.
WARNING:
For the canopy fixture, turn off power at main fuse or 
breaker box and verify that the power is off before 
proceeding with installation or maintenance. 
The canopy fixture must be installed by a qualified 
electrician in accordance with all national and local 
electrical and construction codes and regulations.
WARNING:
Use the track-mount fixture with ceiling-mounted track 
only.
WARNING:
To reduce the risk of fire and electric shock, use the 
track-mount fixture only with the DataTrack (EUTRAC
®
) 
track system.
AVERTIR:
Pour éviter le risque d'incendie ou de choc électrique 
avec le modèle adaptateur pour rail, utiliser uniquement 
avec une alimentation par rail DataTrack (EUTRAC).
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO 
PERSONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING - To reduce the risk of FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:
1) Keep lamp away from materials that may burn.
2) External temperature after 5 minutes of full-brightness operation: 34°C (93°F).
3) External temperature when steady state is achieved: 54°C (129°F).
SAVE THESE INSTRUCTIONS










