User's Manual

20 Irideon FPZ
Shape the Beam
You can shape the beam using the four shutters or with a pattern.
Shape the Beam with Shutters
The fixture has four shutters: left, right, top, and bottom. Each shutter can be
pulled out or pushed in to create the desired beam shape.
Once the shutters are set, you can lock the shutters in place by using a 3 mm
Allen wrench (provided).
Shape the Beam with a Pattern
The fixture has a pattern-holder slot on the top
side of the shutter barrel, in front of the shutter. It
accommodates an E-size (37.5 mm with a
25.4 mm image area) pattern. The maximum
pattern thickness that can be accommodated is
4 mm (0.158”).
When the slot is not in use, a small plastic cover
prevents light leakage.
1: Slide the cover knob on the fixture
completely to the side to expose the slot.
2: Insert the pattern holder.
Note:
• When not using a pattern, remove the pattern holder
and close the cover to prevent distortion of the beam
shape.
• Ensure that the pattern-holder slot is on the top side of
the shutter barrel. If necessary, rotate the shutter barrel
to position the pattern-holder slot on the top side.
Shutter lock
1”
Diameter