User's Manual

User Manual 13
Install Portable Fixture with C-clamp
The C-clamp attaches the fixture to the mounting pipe and allows you to
adjust the position of the fixture once it is mounted. The C-clamp will fit a
3/4” to 2” pipe. Two different length pipe bolts are provided to accommodate
different pipe sizes.
1: Insert the spacer into the driver box through the hole in the top of the
yoke.
2: Tightly fasten the C-clamp to the yoke with the provided yoke bolt and
washers.
3: Place the C-clamp on the mounting pipe, and then tighten the pipe bolt
to secure it. Use the standard pipe bolt to secure the fixture to larger
mounting pipes. If necessary, exchange the standard pipe bolt for the
longer pipe bolt (included) to secure the fixture to smaller mounting
pipes.
Note:
The miniature C-clamp is available only in non-EU
markets. Within the EU, use an M12 bolt to secure a
C-clamp (provided separately) to the fixture.
CAUTION:
Tighten the C-clamp pipe bolt to about 18 in/lb
(approximately finger-tight plus up to one-quarter turn).
Do not use excessive force.
Washers
Pipe bolt
C-clamp
Yoke bolt
Spacer
Detail view
of washers
4: Loosen the C-clamp yoke
bolt and rotate the yoke to
the desired position.
5: Tighten the bolt to lock the
fixture.