User Manual

User Manual 13
Error codes
The following error codes may be seen on the Source 4WRD user interface.
•  indicates the fixture has gone into over-temperature protection.
Reset the fixture to clear the code.
- For DMX mode: Return the DMX control to 0.
- For AC mode: Remove the fixture from power for five seconds and
then restore power.
•  indicates the fixture has gone into under-temperature protection.
Allow the fixture to warm to a minimum of 5°C (41°F).
• Flashing DMX address indicates loss of DMX.
• Dark screen indicates loss of power or fixture time-out. In the event of
time-out, press any button to wake the user interface.
Focus the fixture
Set the Z-adjustment
Use the Z-adjustment knob located on the rear of the Source 4WRD fixture to
adjust the field of the LED light for specific applications.
1: Turn on the Source 4WRD fixture and aim it at a flat surface.
2: Slide the fixture barrel towards or away from the Source 4
WRD LED to
create a hard-edged beam of light.
3: Turn the knob toward PEAK or FLAT until the desired field is obtained.
This shows an ideal beam
of uniform light
Adjust towards PEAK to
blend overlapped beams
Adjust towards FLAT to
improve sharp focus
Adjustment knob