User Manual

14 Source 4 WRD
Adjust the yoke position
Change the height position
1: Remove the yoke locking knobs,
washers, and hex bolts from either
side of the fixture.
2: Raise or lower the fixture to the
desired position within the yoke.
3: Reinstall the yoke’s hex bolts,
washers, and locking knobs.
4: Tighten the yoke knobs to secure in
position.
Set the angle within the
yoke
1: Loosen the yoke locking knob.
Do not remove the knob.
2: Tilt the fixture to the desired
position.
3: Tighten the yoke locking knob
to secure in position.
Shape the beam
You can shape the beam by using the
shutters, a pattern, an optional drop-in iris,
and by rotating the barrel.
Use the color frame
The color frame holder is equipped with a
spring-loaded retaining clip that prevents
color frames and accessories from falling out.
1: Release the retaining clip by pushing it sideways while gently pulling
backwards.
2: Insert the color frame.
3: Lock the retaining clip by pushing sideways while gently pushing
forward.
WARNING:
Make sure all color frame accessories are locked in
position with the retaining clip before hanging the
Source 4
WRD fixture.
Low clearance
position
General use
position
Yoke locking
knob
Retaining
clip