User Manual

8 Source 4 WRD
Retrofit kit installation
Remove incandescent lamp housing
1: Unplug the Source Four
incandescent fixture and
place it on a flat, stable
surface.
2: Loosen the brass thumb
screw located above the
beam adjustment knob. The
lamp housing is now loose
and can be removed.
WARNING:
RISK OF FIRE OR ELECTRIC SHOCK: Source 4 WRD LED
retrofit kit installation requires knowledge of luminaire
electrical systems. If not qualified, do not attempt
installation. Contact a qualified electrician.
Note:
THE RETROFIT KIT IS ACCEPTABLE AS A COMPONENT OF
A LUMINAIRE WHERE THE SUITABILITY OF THE
COMBINATION SHALL BE DETERMINED BY AUTHORITIES
HAVING JURISDICTION.
Note:
The burner assembly is no longer needed. If you would
like ETC to recycle the burner assembly, contact ETC
Technical Services for more information. See Contacting
ETC on page 7.
LEDs
Up and down
navigation
RJ45 data in
and through
User interface
Source 4
WRD LED
Retrofit Kit
A #2 Phillips
screwdriver is
needed for kit
installation