User Manual

EN - 59
EN
• The power cable must not come into contact with hot surfaces and must be routed so
that the temperature does not exceed 75 °C at any point.
• Consult an electrician to see if the home wiring is suitable without further modifications.
Any changes may only be made by a qualified electrician.
The socket should be connected in compliance with
the relevant standard to a adequate circuit breaker.
The method of connection is shown below.
Voltage Wire connection ETA579190000
380 - 415 V 2N ~
1 2
3 4
5
NL1 L2
black brown gray blue yellow/green
220 - 240 V ~
1 2
3 4
5
NL
black brown gray blue yellow/green
• If the cable is damaged or needs to be replaced, this work must be carried out by
a contracted service technician or a certified specialist with prescribed qualifications for
this activity in accordance with current local standards and regulations, otherwise an
injury could occur.
• If the appliance is being connected directly to the mains supply, an omnipolar circuit
breaker must be installed with a minimum gap of 3 mm between the contacts..
• The cable must not be bent or pressed anywhere.