User Manual

EN - 57
EN
Cut a hole in the worktop of the dimension shown in the diafram below.
A minimum of 50 mm space should be left around the hole.
The worktop should be at least 30 mm thick and made of heat-resistant material.
As shown in figure below.
It is essential that the induction hob is well ventilated and that the air intake and exit are
not blocked. Make sure the hob is correctly installed as shown in figure below.
WARNING:
For safety, the gap between the hob and any cupboard above it should be
at least 760 mm.
A (mm) B (mm) C (mm) D E(mm)
760 50 min 20 min air intake air exit 5
Fix the hob to the worktop using the four brackets on the base of the hob. The position
of the brackets ca be adjusted according to the thickness of the top.
C
B
D
A
A - screw ST3.5*8
B - retaining bracket
C - screw hole
D - bottom case